In the case of slatted partition walls featuring 22x70 lamellas, spacing between the slats is 70 mm, while in the case of slatted partition walls featuring 22x90 lamellas, the spacing between the lamellas is 90 mm.

Assembly of a slat wall is carried out in the following steps:

1. Lay all the pieces on the floor
2. Insert the pegs in outermost holes, then using confirmat screws, screw the vertical lamellas with horizontal lamellas.
3. Apply mammoth adhesive on the floor.
4. Place the wall in the designated place and make sure it is perfectly vertical.
5. Drill the holes for mounting pegs in the top slat.
6. Screw the wall with pegs to the ceiling.
7. Mount the side lamellas with pegs and adhesive.

The wall should be 5 mm lower than the height of the room. This is very important during the assembly. It is best to measure the height at 3 points (left-hand side, in the middle, right-hand side) to check for any level differences of the floor or ceiling. If there are any differences, we take the dimension from the point of the lowest height.

The ready-made kit does not require processing. The kit includes trimmed and drilled lamellas, peg connectors, confirmat screws. The kit does not include screw anchors for the ceiling and adhesive.

Free-standing/openwork lamellas are single slats intended for further processing and assembly on their own, whereas prefabricated openwork walls are trimmed and drilled sets ready for assembly. They do not require further processing - they just need to be screwed together.

The maximum height is 275 cm, while the maximum width is 271.2 cm.

It is not a standard product, it is a custom-made product developed accordingly to the dimensions provided by the customer. For this reason it is non-refundable. Please make thoughtful purchases.