We offer lamellas with in length of 275 cm, with the exception of veneered lamellas, which are 270 cm long. This is the maximum length of slats that we can manufacture. The exact length is always given in the product specification table.

We offer three slat dimensions: STANDARD 30x40 (mm) MINI slats 16 x 30 mm, OPENWORK slats 22 x 70 and 22 90 x mm and laths on felt and HDF panel 30 x 275 cm.

We offer two types of slats, one made of MDF covered with laminate or slats made of MDF covered with natural oak veneer.

Slats can be mounted directly to the wall or ceiling using a good quality mounting adhesive (Mammoth adhesive). One adhesive is enough for 12-15 pieces of slats.

Our slats are ideal for separating rooms, as a decorative freestanding wall, an elegant openwork partition. We recommend slats with dimensions of 22x70 mm, 22x90 mm or ready-made free-standing slat walls.

The recommended spacing between the slats is the same as the width of one slat. However, this is an individual matter for each customer.

The number of slats depends on the adopted spacing between the lamellas. E.g. For a 100-cm wide wall with the use of 3x4 slats, we suggest purchasing 17 lamellas, assuming a 3-cm wide spacing between them.

In order to make an appropriate choice of the color of the slats, we suggest purchasing a set of samples from our store.

Unfortunately, we do not offer the service of cutting the slats to a customized size.

Wall slats can be mounted above the skirting, however, you can completely resign from the skirting and mount them starting from the floor.

The slats have been prepared in brushed veneer – intended for oiling or coating.

One panel on felt is 30 cm wide x 2.4 cm deep x 275 cm long.

The spacing between the lamellas is 2 cm.

We offer felt in three colors: black, gray and beige.

The felt thickness is 8 mm.

Finishing strips are not included. They are sold separately by units. The strips are optional, however, we recommend using them to make installation easier and the wall better protected.

No. The ends are open and the inner material is visible.

In this variant, the lamellas do not have systemic ends allowing for mounting to the ground. For this purpose, use the adhesive applied at the end of the lamella or in the space between the lamella and the substrate (mounting clearance of few mm is recommended). You can also use a mounting peg or a screw screwed at an angle. With this variant, however, a screw head will be visible.

The lead time is always given in two stages - separately the estimated time of order completion and separately the estimated delivery date.

The lead time for preparing the order for shipment is always shown on the product card under the product title.

The delivery time depends on the carrier and we also provide an estimated time based on our historical deliveries.